BorMann PRO BBC8010 Mode D'emploi page 3

EN
Technical data
Capacity:
Input:
Output:
Starting Current:
Peak Current:
Lifetime
Operating instructions
Indicator lights
Press the switch to check the storage level of Jump Starter.
The indicator will flash one by one during the period of charging.
Different number of solid indicators show different storage level of Jump Starter.
All indicators light up when the charging is paused or completed.
Indicator Unlit 5 flashing
lights
Ba ery 0% 10%
capacity
Charging the device
1. Plug the USB adapter into a universal socket.
2. Plug the 3-in-1 charger cable into the USB port of the adapter.
3. Connect the 3-in-1 charger cable to the 5V 2.4A input on the device.
For jump start of 12V vehicle
1. Make sure that the number of indicator lights is not less than 3.
2. Connect the red battery clamp of jumper cable to the vehicle's positive (+) battery
terminal and connect the black battery clamp of jumper cable to the vehicle's negative
(-) battery terminal.
3. Plug the cord of jumper cable into the jump start socket.
4. Start the vehicle.
5. When the vehicle starts, remove jumper cable from Jump Starter and disconnect
red and black clamps to the vehicle battery terminals within 30 seconds.
6. Leave the vehicle's engine running.
Charging mobile phones or tablets
1. Plug the switch cable B to USB 5V 2A output port.
2. Select appropriate connector for your mobile phones or tablet and connect it to the
switch cable B and your mobile phone or tablet.
3. Press the switch button to charge.
Charging/power supply to Notebooks
Plug the switch cable to USB 19V 3.5A output port.
2. Select appropriate connector for your Notebook and connect it to the switch cable A
and your Notebook.
3. Press the switch button to charge/power supply.
3
8000 mAH
5V 2,4A
1) 5V/1A USB, 5V/2A USB
2) 19V/3.5A for Laptops
3) LED Flashlight (On, Strobe, SOS)
4) 12V emergency Jump Start up
200A
400A
1000 Cycles
1 solid 2 solid
20% 40%
WWW.NIKOLAOUTOOLS.GR
* The manufacturer reserves the right to make minor changes to product
design and technical specifications without prior notice unless these changes
significantly affect the performance and safety of the products. The parts
described / illustrated in the pages of the manual that you hold in your hands
may also concern other models of the manufacturer's product line with similar
features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all
repair, inspection, repair or replacement work, including maintenance and special
adjustments, must only be carried out by technicians of the authorized service
department of the manufacturer.
* Always use the product with the supplied equipment. Operation of the
product with non-provided equipment may cause malfunctions or even serious
injury or death. The manufacturer and the importer shall not be liable for
injuries and damages resulting from the use of non-conforming equipment.
3 solid 4 solid 5 solid
60% 80% 100%