First Use - Smeg 123443 Manuel D'utilisation

3.2 First use

1. Insert the plug into an electrical socket.
2. Press the ON /OFF button.
display shows the flashing symbols.
3. Set the time using the lever (1).
4. Set the hour value by moving the lever up
to increase the value or down to
decrease the value.
5. Confirm the value by placing the lever in
the central position and pressing it: the
appliance will beep.
6. Set the minute value following the same
procedure.
7. After confirming the minute setting, an
acoustic signal sounds and the device
activates CLOCK mode.
Use
Setting the water hardness
Set the water hardness value by selecting
one of the three levels available: HARD,
The
MEDIUM and SOFT.
1. Hold down the
simultaneously for 3 seconds: the display
shows HA03.
2. Use the lever, moving it up or down to set
the desired level: H0A1(soft), H0A2
(medium) and H0A3 (hard).
3. Move the lever to the central position
and press to confirm the value: the
appliance will beep to confirm the
selection made.
and buttons
11