Atag HG6492EBA Mode D'emploi page 12

CONVERSION INSTRUCTION
Check for gas tightness and operation (D)
EN 6
1. Replace the injectors in the burners.
Use a socket spanner (7) for disassembling/assembling the injectors
in the burners (see illustration C2, at the back of this instruction).
2. Replace the simmer setting screws in the taps.
Use a screwdriver, flat-blade 4, for disassembling/assembling of
the simmer setting screw (see illustration C4, at the back of this
instruction) and when necessary use pliers.
3. On the wok burner, replace the injectors for outer (H1) and inner
(H2) burner using an open end spanner (7).
The injector for the outer burner is the one at the bottom, the upper
injector is for the inner burner. (Illustration C3, at the back of this
instruction)
4. Install the silicon sealing plugs, marked with a letter A, B and C in
the air holes of the corresponding burners (see illustration C7).
5. Place the label 'H1' in the appropriate box on the current appliance
identification card in the bottom tray of the appliance (see
illustration C1, at the back of this instruction).
6. Place the label 'H2' in the appropriate box on the current appliance
identification card at the underside of the appliance (see
illustration C5).
7. Place the label 'G2' in the appropriate box on the current appliance
identification card on the back of the user manual (see
illustrations C6, at the back of this instruction).
When the appliance is connected to the gas supply, use leakage
test spray to check the gas tightness:
1. Seal the injector.
2. Open the gas tap.
Attention; press and open tap with thermo electric safety device and
keep it pressed down.
3. Spray leakage test spray on the connections and check for gas
tightness (see illustration D, at the back of this instruction).
4. Repeat for every burner.