Connection Diagrams - Denon DJ LC6000 PRIME Guide D'utilisation

Setup
Important: Occasionally, we may update LC6000 PRIME's firmware to add exciting new features and
improvements. Visit denondj.com
software (firmware updates may address new software features).
1. Make sure all of your devices are powered off or all of their volume levels are at their minimum positions.
2. Connect LC6000 PRIME's USB port to an available port on your computer or a compatible Denon DJ media
player.
3. Connect any output devices (headphones, power amplifiers, loudspeakers, etc.) to the outputs of your mixer.
4. Connect all of your devices to power sources.
•
When starting a session, power on (1) LC6000 PRIME and other accessories or input sources, (2) your
mixer, and then (3) output devices.
•
When ending a session, power off (1) output devices, (2) your mixer, and then (3) LC6000 PRIME and
other accessories or input sources.
5. If you are using LC6000 PRIME with supported third-party software such as Virtual DJ or Algoriddim djay,
select the deck that LC6000 PRIME will control. See

Connection Diagrams

Items shown but not listed under
Example 1
This example shows an LC6000 PRIME controlling the second layer of an SC6000 PRIME or SC5000 PRIME
media player connected to an X1850 PRIME mixer.
SC6000 PRIME
(rear panel)
to check for available firmware updates, especially after you update your
Introduction > Box Contents
X1850 PRIME
(rear panel)
Power outlet
Operation > Deck Selection
are sold separately.
for more information.
LC6000 PRIME
(rear panel)
3