Skil SR232301 Guide D'utilisation page 11

OPERATING INSTRUCTIONS
WARNING
reduce the risk of starting the tool accidentally.
Backing Pad Removal/Installation
Your Multi-Function Detail sander is equipped
with a hook- and-loop rubber backing pad that
may be removed and attached without the
need for additional tools.
To remove, push the button for changing the
foot plates and pull the backing pad free from
the sander (Fig. 2).
Rotating Backing Pad
For maximum use of the sandpaper, rotate the
pad 120 degrees when the tip of the sandpaper
becomes worn (Fig. 3).
Installing Sandpaper
Your sander uses hook-and-loop backed sand-
paper, which firmly grips the backing pad when
applied with moderate pressure.
To change, merely peel off the old sandpaper,
remove any dust from the backing pad, and
press the new sandpaper in place. Be sure to
align the sanding sheet holes with the holes
in the backing pad to allow the dust extraction
system to function (Fig. 4).
Disconnect the plug from the power source before any assembly,
adjustments or changing accessories .
Such preventive safety measures
Fig. 2
Fig. 3
Fig. 4
11