Casio GRAPH35+ E II Mode D'emploi page 410
Masquer les pouces
Voir aussi pour GRAPH35+ E II:
- Mode d'emploi (43 pages) ,
- Mode d'emploi (452 pages) ,
- Mode d'emploi (6 pages)
Publicité
Important!
• Do not install Add-in E-CON2 on a calculator that has E-CON3 installed.
Doing so may cause operational problems.
• All explanations in this section assume that you are fully familiar with all
calculator and Data Logger (CMA CLAB* or CASIO EA-200) precautions,
terminology, and operational procedures.
• The E-CON3 application is designed to get the most out of the
measurement functions of the CASIO EA-200 Data Logger. Though
it can run on a CMA CLAB Data Logger, CLAB does not have a
SONIC port, microphone, or speaker as is equipped on the EA-200.
While a calculator is connected to a CLAB Data Logger, attempting to
configure E-CON3 application settings and perform measurement using
parameters that are not supported by CLAB will cause an error.
• Unless specifically indicated otherwise, all page references in this
"E-CON3 Application" chapter are to pages in this chapter.
* For information about CMA and the CLAB Data Logger, visit
http://cma-science.nl/.
Publicité
