EQUATION OH-4B Manuel D'instructions page 61

INSTALLATION
Feet Assembly
• Insert the 2 feet until they are clipped.
Connection
• This device is mobile type and can be moved while respecting the safety
instructions.
• Place the radiator on a dry, stable and clean surface.
• A minimum distance of 1m must be provided between the walls of the
appliance and any obstacle (furniture or walls for example) to allow
good air circulation.
• INDOOR USE ONLY
• The appliance must be earthed.
• Connect the plug to a 220-240V~,50-60Hz wall socket
• Unplug the appliance when it is not in operation
USE
Adjust the thermostat
low Heater
high Heater
• Place the button on desired position to start the heater.
• Place the button to the lowest position to turn off the heater.
Thermostat adjustment :
40 40
30 30
20 20
10 10
0 0
-10 -10
Place button on max power.
An anti-tilt switch is located in the device, it automatically cuts off the power in the event of a fall or
movement of the device.
A thermal cut out protection switches off heating automatically in case of severe overheating. In this case,
turn off the device, eliminate the cause of the overheating, and allow it to cool before using again.
Adjust the thermostat
Heating indicator
40 40
40 40
30 30
30 30
20 20
20 20
10 10
10 10
0 0
0 0
-10 -10
-10 -10
Wait until the desired room Turn slowly the button until
temperature is reached. the appliance switches off
(the heating indicator goes
out)
220-240V~
50-60Hz
40 40
30 30
20 20
10 10
0 0
-10 -10
40 40
30 30
20 20
10 10
0 0
-10 -10
The appliance will heat as
soon as the room temperature
drops to maintain this set
temperature.
EN
61