Dimplex Ignite 60 Manuel Du Propriétaire page 12

Operation
Figure 5
C
C. Heat ON/OFF
Turns the heater On and Off.
→ Activated by pressing the
button on the remote.
• Indicated by the
setpoint temperature will flash
on the display, then the intake
temperature will be displayed
before turning off.
! NOTE: After the heater is
switched off, there is a 2 minute fan
delay, where the fan will continue
running before turning off.
! NOTE: The unit can be operated
in Heat Only Mode. When the unit
is only running with the heater,
the icon will continuously be
displayed on the Display.
! NOTE: The heater may emit
a slight, harmless odor when
first used. This odor is a normal
condition caused by initial heating
12
A
J
Display
icon and the
H I
of internal heater parts and will not
occur again.
D Temperature Down
Decreases the temperature setting.
→ Adjusted by repeatedly pressing
the corresponding button on the
remote.*
• Indicated by setpoint temperature
on the Display decreasing and
the speed of the fan decreasing
to reduce the amount of heat
being projected into the room.**
E. Temperature Up
Increases the temperature setting.
Figure 6
A
B
D
F
H
C
E
G
I
J