Publicité
CHEMICALS
All chemicals (including petrol, battery acid,
corrosive materials and solvents) should be
regarded as harmful. If your Deckvest comes in
contact with chemicals, please notify Spinlock,
stating the precise chemicals concerned. We
will investigate and give our advice.
WARNING: The deck safety harness and safety
line may transmit very large forces. Only
attach to strong hooking points or jack-lines.
The deck safety harness and safety line are
intended to prevent the user falling overboard.
They do not provide protection from falls at
height. It is unsafe to wear this harness loose,
the harness shall be worn tightly in order to
be effective.
MAJOR FALLS
In the event that your full body weight is
dropped a distance and then stopped, do
not continue to use this product. Even if no
external changes are visible, internal damage
may have reduced its strength and its margin
of safety. Do not hesitate to contact Spinlock
in case of doubt.
Anchorage point should be located at the
centre of the chest. Ensure no sharp edges
on safety line attachment point. Use with an
approved personal safety line only. Attach to
Jack line / fixed eyes. Anchorage points must
be able to withstand forces of more than 1
tonne. Never attach to lifelines / standing or
running rigging.
LIFETIME = SHELF LIFE + USEFUL LIFE
After first use this product should last 5
years. Certain environmental elements will
considerably accelerate wear: salt, sand and
chemicals.
In exceptional circumstances, wear or damage
could occur on the first use which reduces the
lifetime of the product to that one, single use.
Shelf-life of this product in good condition is
up to 3 years before first use.
TEMPERATURE
Use this product only above a minimum of -30°
C and below a maximum of +60° C. When the
temperature is below freezing, even a fully
charged cylinder may not adequately inflate
your lifejacket. If this occurs use the oral tube
to manually top up your lifejacket after the CO
has been discharged (and not before).
WARNING: In cold environments inflation may
be slower and lower performance may result
DISINFECTING THE PRODUCT
When necessary, use a disinfectant that
is compatible with polyamide, polyester,
polycarbonate, PVC etc.
Use diluted with clean water at a maximum
temperature of 30° C. After soaking for an
hour, rinse in clean cold water. Dry slowly,
away from direct heat.
RESPONSIBILITY
Spinlock is not responsible for the
consequences, direct, indirect or accidental, or
any type of damage befalling or resulting from
the use of its products.
WARRANTY
This Deckvest qualifies for a special Spinlock
Warranty lasting five years when you register
online as first owner. Full details of how this
operates, what it covers and does not cover
are important to note and are explained on the
Registration homepage www.spinlock.co.uk
Certain environmental elements will
considerably accelerate wear: salt, sand,
moisture, chemicals. In exceptional
circumstances, wear or damage could occur
on the first use which reduces the lifetime of
the product to that one single use. See www.
spinlock.co.uk for full details.
2
12
Publicité
