Garland 1080 TQG Manuel D'instructions page 28

English
Remove all keys or hand tools from the machine and
the work area before starting the machine. A wrench
or tool left near the machine may be touched by a part
of the machine in motion and to project itself causing
personal injury.
Do not exceed yourself. Keep both feet firmly in place
on the ground and maintain balance at all times.
When using this machine, wear the following
protective equipment: Eye and hearing protection and
safety gloves.
When in use, the machine produces more than 90 dB
A, you must use hearing protection. If the ears are not
protected, there is a serious ears damage risk.
Dress properly. Do not wear loose clothing or jewelry.
2.3. SAFETY IN THE WORK AREA
Do not operate this machine in explosive atmospheres
as well as in the presence of flammable liquids, gases
and dust.
Never start the machine in enclosed areas such as
rooms or garages. This machine emits dangerous
gases through the exhaust pipe that will accumulate
in the area causing the air to be toxic and harmful
to the health of people, animals and plants that are
inside the area. Do not start the machine in a room or
enclosure. The exhaust fumes and fuel fumes contain
carbon monoxide and harmful chemicals. In case of a
concentration of gases produced by poor ventilation,
remove all that impedes the flow of clean air from the
work area to improve ventilation and do not return to
work in the area unless you have correctly ventilated
the area and are certain that ventilation is sufficient as
to not happen again this concentration.
The area within a radius of 10 meters around the
machine should be considered risk area in which no
one must enter while the machine is running (security
area). When necessary, use ropes and warning signs
to mark the security area.
Maintain children and curious persons away from the
work area while operating this machine. Distractions
can cause a loss of control. Make sure that children,
people or animals do not come into your work area.
When the work must be performed simultaneously
by two or more persons, always check the presence
and location of others in order to maintain a sufficient
distance between each person to ensure safety.
Do not use this machine at night, with fog or low
visibility which will not allow you to see the working
area clearly.
Keep the work area clean and work with good lighting.
Only use this machine with daylight or with good
artificial lighting. Cluttered and dark areas cause
accidents. Inspect and remove any objects that can
cause damage to you or the machine.
2.4. SAFETY IN THE USE OF FUELS
IMPORTANT: The fuel used for this machine
is highly flammable. If the fuel or the
machine ignites, smother the fire with a dry
powder fire extinguisher.
Petrol and oil are hazardous; avoid contact of gasoline
or oil with the skin and eyes. Do not inhale or swallow
them. Immediately see your doctor if you ingest fuel
or oil. If they come into contact with fuel or oil clean
with soap and water as soon as possible, if you then
28/148