Schweizer eMag 240 HD Mode D'emploi page 11

1. Connect the power cable: from the middle power connector on the back of the eMag 240 HD to a wall
outlet.
2. Press the white master power switch near the LED reading light on the right side of the eMag 240 HD.
3. Press the green power switch on the right side of the control panel.
Note: If the screen remains blank, check that the monitor is turned on.
4. Hold the sides of the monitor with both hands and move it up or down to change the height, or turn the
monitor left or right to adjust the angle for the best view.
If the monitor will not move to the left or right, make sure that the arm lock located at the base of the
monitor arm is released (push the locking pin in). Also, make sure that the monitor is raised so that it
can move freely from left to right.
For further information on the monitor arm lock, see the section Transporting and Moving the
eMag 240 HD as already mentioned in this document.
11