Kostal Smart Energy Meter G2 Manuel D'installation page 112

Installation instructions
The KOSTAL Smart Energy Meter is not in the same local network.
n
Connect KOSTAL Smart Energy Meter with the same router / switch.
The serial bus LED is lighting up red or flashing orange
In the user interface check whether there are any error messages about com-
munication with the receiver.
n
If necessary, check cabling to receiver.
The KOSTAL Smart Energy Meter is providing unrealistic measuring
values.
The KOSTAL Smart Energy Meter has been installed the wrong way round.
n
Recheck how L1 to L3 are connected.
n
The transformers are not configured. Go to Device settings > Transformer
ratio, activate transformer and set the correct transformer ratio.
The user interface cannot be called up using the KOSTAL Smart Energy
Meter's IP address.
n
Contact the network administrator.
Environmentally friendly disposal
The KOSTAL Smart Energy Meter must not be disposed of in your
non-recyclable waste bin.
Dispose of the KOSTAL Smart Energy Meter in line with the disposal
requirements for electrical waste applicable locally.
112 © 2022 KOSTAL Solar Electric GmbH