Whirlpool WOES5030L Guide De Dimensions page 6

DIMENSION GUIDE
Electrical Connection
To properly install your oven, you must determine the type of
electrical connection you will be using and follow the
instructions provided for it here.
■ Oven must be connected to the proper electrical voltage and
frequency as specifi ed on the model/serial/rating plate. The
model/serial/rating plate is located under the control panel
on single ovens. See the following illustration.
A. Model/serial/rating plate
■ Models rated from 7.3 to 9.6 kW at 240 V (5.4 to 7.4 kW at
208 V) require a separate 40 A circuit. Models rated at
4.8 kW and below at 240 V (3.6 kW and below at
208 V) require a separate 20 A circuit. This model requires a
separate 20 A circuit.
A
SINGLE OVEN
■ A circuit breaker is recommended.
■ Connect directly to the fused disconnect (or circuit breaker
box) through fl exible, armored or nonmetallic sheathed,
copper cable (with grounding wire). See the "Make Electrical
Connection" section in the Owner's Manual.
■ Flexible conduit from the oven should be connected directly
to the junction box.
■ Fuse both sides of the line.
■ Do not cut the conduit. The length of conduit provided is for
serviceability of the oven.
■ A UL listed or CSA-approved conduit connector must be
provided.
■ If the house has aluminum wiring, follow the procedure
below:
Connect the aluminum wiring using special connectors
and/or tools designed and UL listed for joining copper to
aluminum.
Follow the electrical connector manufacturer's recommended
procedure. Aluminum/copper connection must conform with
local codes and industry-accepted wiring practices.
6 of 18