Publicité
Les langues disponibles
Les langues disponibles
DIMENSION GUIDE
Single Ovens Undercounter - without cooktop
installed above
A
E
F
G
H
30" (76.2 cm) models
A. Recommended junction box location
B. 3/4" (1.9 cm) top cleat*
1
C. 30
⁄
" (76.8 cm) minimum width of flush inset cutout
4
D. 28
7
⁄
" (73.3 cm) minimum width of opening
8
E. 29
1
⁄
" (74.3 cm) minimum height of flush inset cutout
4
1
F. 28
⁄
" (72.4 cm) recommended cutout height
2
G. 11/16" (1.7 cm) side cleat*
H. 1/4" (0.64 cm) spacer the entire depth of the cabinet*
I.
4
5
⁄
" (11.7 cm) bottom of cutout to floor
8
*Cleats and spacers must be recessed 1
front of the cabinet
.
A
C
D
30" (76.2 cm) models
A. 2" (5.1 cm) spacer the entire depth of the cutout*
B. 25" (63.5 cm) depth of cutout
C. 1
3
⁄
" (3.5 cm) recess from front of cabinet
8
D. 11/16" (1.7 cm) side cleat*
*Cleats and spacers must be recessed 1
front of the cabinet
.
B
C
D
G
H
I
FRONT VIEW
" (3.5 cm) from the
⁄
3
8
A
B
D
TOP VIEW
" (3.5 cm) from the
3
⁄
8
Cutout Dimensions For Ovens Installed Under
Cooktop
IMPORTANT: Observe all governing codes and ordinances.
Cooktop must be approved for use over an oven. See cooktop
Installation Instructions for cutout dimensions. Center the
A
cooktop cutout over oven cutout.
Ovens approved for this type of installation have an approval
label located on the top of the oven.
To avoid damage to your cabinets, check with your builder or
cabinet supplier to make sure that the materials used will not
discolor, delaminate or sustain other damage. This oven has
been designed in accordance with UL and CSA International
and complies with the maximum allowable wood cabinet
temperatures of 194°F (90°C).
Approved Built-In Oven and Electric Coil/Radiant/Induction
Cooktop Combinations or without Cooktop Installed above
Oven
I
G
A. 24" (61 cm) cabinet depth
B. 25" (63.5 cm) countertop depth
C. Recommended oven and cooktop junction box locations
D. Allow 5/8" (1.6 cm) for oven trim to overlap on each side.
3
E. 27
⁄
" (70.5 cm) minimum cutout height
4
F. 36" (91.4 cm) from cabinet base to countertop
G. 4
5
⁄
" (11.7 cm) maximum from cabinet base with feet installed. If
8
dimension "F" is greater than 36" (91.4 cm), dimension "G" can be
increased the same difference for induction combinations.
H. 28
1
⁄
" (72.4 cm) minimum oven cutout dimension
2
I.
31
3
⁄
" (82.2 cm) from top of countertop to bottom of cutout
8
For the approved model number combinations, refer to the
undercounter label located on top of the oven chassis and
on the bottom of the cooktop burner box.
NOTE: For undercounter installation, it is recommended that the
junction boxes for oven and cooktop be located in the adjacent
right or left cabinet. A 1" (2.5 cm) minimum diameter hole should
have been drilled in the upper rear right or left corner of the side
wall surface to pass the appliance cable through to the junction
box.
A
C
E
D
H
4 of 18
B
C
F
Publicité
