Publicité
Les langues disponibles
Les langues disponibles
DESCRIPTION
1.
Steam head
2.
Integrated hanger
2a*
Integrated collapsible hanger
2b*
Integrated hanger
3.
Trouser clips
4.
Steam head hook
5.
Hanger holder
6.
Hanger fastening screw
7.
Pole locking clips
8.
Telescopic pole
9.
Steam hose plus hose exit and locker
10.
Electrical cord hook
11.
Electrical cord
12.
Transport handle
13.
Water tank filling inlet
BEFORE USE
1 • Garment steamer assembly
Hose assembly
1. Insert and then lock it by turning anti-clockwise
2. Ensure that the hose is properly locked by gently pulling vertically.
Pole assembly
1. Completely pull out the 2 stability legs from the base.
2. Unscrew the pole fastening screw on the base of the pole.
3. Hold the pole such that the electrical cord hook is at the back. Check that the 3 pole locking
clips are unlocked.
Make sure the 4 segments of the pole are fully extended then lock the 3 pole locking clips.
4. Insert the pole on the base by pressing downwards until the holes of the pole and base are
at the same level, so that you can put the screw back. If the holes are not aligned, check
that the pole is fully extended.
Integrated Hanger assembly
1. Unscrew the hanger fastening screw at the bottom of the hanger.
2. Hold the hanger such that the hanger holder is on the same side as the appliance control
panel.
3. Insert vertically the hanger on the top of the pole. The holes at the bottom of the hanger
and in the pole should be at the same level.
4. Put the screw back and screw in as far as it will go so that the hanger is firmly fixed to the
pole.
(fig. 9)
5. Install the steam head on top of the integrated hanger.
6
(fig.
5). Adjust the pole to its maximum height by sliding it upwards.
(fig.6)
14.
Variable steam settings
15a.
Stability leg
15b.
Stability leg
16.
Pole fastening screw
17.
ON/OFF switch
18.
Housing
19.
"Anti calc" screwing cap & entry
20.
Stability base
21.
Press & Steam vertical support*
22.
Press & Steam pouch*
23.
Press & Steam locking handle*
24.
Press & Steam locking hook*
25.
Glove*
26.
Fabric brush*
27.
Lint pad*
(fig. 3)
(fig. 1, 2)
(fig. 9)
* depending on model
Publicité
