Palmer MONICON XL Manuel D'utilisation page 8

8
9
21
INPUT SELECT IN 1 - IN 2 - IN 3
7
Buttons for selecting and activating the signal sources Line input IN 1 to IN 3 on the back of the device
(No. 3 and No. 4). The button corresponding to the active line input illuminates. You can choose between
two modes of operation when selecting the signal source.
Mode of operation A: All signal sources can be selected and activated at the same time (factory default).
Before changing the setting, switch off all connected monitors and headphone amplifiers. To select the
mode of operation A "Multi mode," switch off the monitor controller, press the IN 1 button on INPUT SELECT,
and hold down the button until the monitor controller has been switched on again.
Mode of operation B: A single signal source can be freely selected and activated. The previously activated
signal source will be deactivated upon selecting another signal source. To select the mode of operation B
"Individual mode," switch off the monitor controller, press the IN 2 button on INPUT SELECT, and hold down
the button until the monitor controller has been switched on again.
INPUT 3 AUX
8
Level control to adjust the volume of the INPUT 3 AUX line input.
AUX / S/PDIF
9
Switch for selecting INPUT 3's analog or digital input source. In the switched-down position, the L/R analog
cinch input or 0.14 inch stereo jack input is activated; when not switched down, the SPDIF IN digital coaxial
connector is activated.
8
7 16 17
15
13
16 10
19
12
20
14
11
18