Publicité
Les langues disponibles
Les langues disponibles
Before you operate the product
WARNING:
instructions before you operate the
product.
•
Use the blower with the lowest possible throttle.
A lower throttle means less noise and less dust,
and it is also easier to keep control over the
rubbish collected together/moved. Use a rake or
a brush to release rubbish stuck to the ground.
•
Use the minimum number of blowers along with
other equipment to reduce the sound level.
•
Hold the opening of the blower as close to the
ground as possible. Utilize the entire length of
the blow pipe to keep the air current close to the
ground. Clean up afterwards. Make sure that you
have not blown rubbish into someone's garden.
Operate power equipment only at reasonable
hours, not early in the morning or late at night
when people might be disturbed. Comply with
times listed in local ordinances.
•
This blower is a backpack type, and is carried
using a shoulder harness while operating. It is
operated and controlled with the handle on the
tube using the right hand.
•
The speed of the air jet is regulated by means
of the throttle. Select the speed best suited for
respective tasks.
•
Check that the air intake is not blocked, for
example, by leaves or rubbish. A clogged air
intake reduces the machine's blowing capacity
and increases the engine's working temperature,
which can result in engine failure. Stop the
engine and remove the object.
•
Be aware of the wind direction. Work with the
wind to make your work easier.
•
Using the blower to move large piles is time
consuming and creates unnecessary noise.
•
Keep a good balance and a firm foothold.
•
When work is finished the machine should be
stored vertically.
To operate the throttle control and
the stop switch (EBZ9000)
•
Apply full throttle (A).
•
Apply idle speed (B).
•
Stop the product with the stop switch (C).
C
2318 - 002 - 17.11.2023
Read the safety
A
B
To operate the throttle control
(EBZ9000RH)
•
To increase the blower speed during operation,
push the throttle control until you get the correct
speed.
•
To decrease the blower speed during operation,
release the throttle control until you get the
correct speed.
To operate the stop switch
with throttle position adjustment
(EBZ9000RH)
The stop switch with throttle position adjustment (A)
lets you set the blower speed without the throttle
control.
•
To increase the set blower speed during
operation, push the stop switch (A) up.
•
To decrease the set blower speed during
operation, push the stop switch down.
•
To stop the product, push the stop switch down
fully.
A
13
Publicité
