Display; Control Unit; Charger; Replacing Components Of The Fast Pedelec - Derby cycle Impulse Speed 2.0 Mode D'emploi Original

If you remove the motor rom the rame of your Pedelec,
check the plug rom the motor and battery cable socket for
dirt. If necessary, clean careully with a dry cloth before
reconnecting.

10.3 Display

The housing of the display must only be cleaned with a
damp (not wet) cloth.

10.4 Control unit

The control unit can be cleaned with a damp cloth if nec-
essary.

10.5 Charger

Always unplug the charger rom the wall socket
before cleaning to avoid a short-circuit and physi-
cal injury.
Make sure that water does not enter the charger when
cleaning.
28 Original User Manual | Pedelec Impulse Speed 2.0
11 Replacing components of the fast
Pedelec
As your S-Pedelec is a Category L1e moped, it is neces-
sary to obtain a permit rom the Federal Motor Transport
Authority and the technical inspection authority (TÜV),
as is the case with other motor vehicles in Germany. This
S-Pedelec has such a permit.
During the approval process, speciic components were
deined as being suitable for use with this vehicle. This
means that the permit for your S-Pedelec only remains
valid if exactly the same approved components are used.
If components are modiied or replaced, the same require-
ments apply as for other motor vehicles. You must only
use replacement parts that are certiied as approved for
your S-Pedelec. Alternatively, you can have components
approved individually by the technical inspection author-
ity (TÜV).
The following lists show which components of your fast
Pedelec can be replaced and what rules apply.
11.1 Components that can only be
replaced with the same or approved
parts
• Frame
• Fork
• Motor unit
• Battery
• Tyres
• Wheel rims
• Brake system
• Front light
• Rear light
• Licence plate holder
• Side stand
• Handlebar
• Handlebar stem
11.2 Components that do not require a
certiicate of approval
• Cranks
• Pedals: Providing type-approved pedal relectors
are used.
• Mudguard: The ront edge of the ront mudguard
must be rounded.
• Pannier rack
• Saddle
• Handlebar grips