Quick Start; Battery - Derby cycle Impulse Speed 2.0 Mode D'emploi Original

4 Quick start

Charge the battery completely before riding for the irst
time. Charge temperature: 0°C to 45°C.
SEAT TUBE BATTERY
Charging the battery
1. Remove the cover rom the charging socket.
2. Connect the plug of the charger to the battery.
DOWN TUBE BATTERY
Charging the battery
3. Plug the charger in at the wall socket.
You must charge the battery completely before
using it for the irst time. As required by transport
law, the battery leaves the factory with an ap-
proximately 30% charge.
You can also remove the battery rom your S-Pe-
delec and charge it elsewhere. For more informa-
tion, refer to Chapter 5 "Battery". Please note,
the battery is heavy. Hold on tight to it!
SEAT TUBE BATTERY
4. Once all of the battery LEDs have gone out, the battery
is ully charged. Pull the plug of the charger out of the
charging socket and unplug the charger at the wall
socket.
5. a) Down tube battery: If you removed the battery for
charging, replace it in the holder rom the ront/above.
At the same time, the key must be in the lock and must
be turned anticlockwise. Press the battery down into
the holder until the locking mechanism engages.
b) Seat tube battery: If you removed the battery for
charging, reinsert it into the holder on the S-Pedelec
rom the let-hand side. Tilt the battery outwards at an
angle of roughly 45° as you do so. Swivel the battery
into the upright position until the locking mechanism
engages.
DOWN TUBE BATTERY
Installing the battery
6. Now turn the key clockwise and remove it. The battery
is now locked in place.
DOWN TUBE BATTERY
Locking the battery
7. Make sure that the battery is securely positioned and
that the key is no longer in the lock.
Original User Manual | Pedelec Impulse Speed 2.0
SEAT TUBE BATTERY
SEAT TUBE BATTERY
11