Makita EM4350RH Instructions D'emploi D'origine page 18

HOW TO START AND STOP ENGINE
Observe the applicable accident prevention regulations!
STARTING
Move at least 3 m away from the place of refuelling. Place the unit on the ground taking care that the cutting tool does not come into contact with
the ground or any other objects.
A: Cold start
1) Set this machine on a flat space.
2) Set the I-O switch (1) to OPERATION (2).
3) Choke lever
Close the choke lever.
Choke opening:
Full closing in cold or when the engine is cold.
●
Full or half opening if the engine is a bit warm, such as restarting engine
●
just after stopping during warm-up operation.
4) Primer pump
Continue to push the primer pump (3) until fuel comes into the primer pump.
(In general, 7 to 10 pushes.)
If the primer pump is pushed excessively, an excess of gasoline returns to
the fuel tank.
18
(2)
(1)
(3)