Domo DO-262A Mode D'emploi page 60

DO-262A
INSTALLATION WALL KIT
The air outlet hose must be used in the "cool" or "auto" mode.
During the "fan" or "dry" mode, you don't need to attache the
air outlet hose.
- Make an opening in the wall the size of the wall adapa-
tor.
- Place the wall adaptor in the opening.
- Place the round ring on the air outlet hose.
- Place hose with the round ring on the wall adaptor.
NOTE : Make sure the air outlet hose isn't bend during use.
Make sure there is a free surrounding of at least 50 cm around the
outlet.
DRAINING
During the "dry" mode you can use a permanent drainage.
- Remove the permanent drain plug.
- Attache the drain hose on the permanent drain.
- Make sure the water is drained in a save and permanent way.
When you don't use the permanent drain, the non recycled condesation
water, will be stored in the water tank.
- When the water tank is full a few beep signals will be heard
and on the display the code P1 will appear. The "cool" or
"dry" mode will end automatically. The fan will continue to operate, this is
normal.
- Move the unit over to a place where you can easily drain the water.
- Remove the drain plug at the bottom of your unit and drain the water.
- After fully draining the water tank, place the drain plug
back on the drain opening.
- Restart the unit, make sure the error code P1 is no longer
displayed. When the code doesn't disappear, try turning
off and on the unit a few times. When the error code continues, please contact
the after sales service.
NOTE : always make sure to install the drain plug, before turning
the unit back on.
CLEANING AND MAINTENANCE
Important :
- Always remove the plug from the socket before cleaning the unit.
- Never use any chemical or abrasive products to clean the unit.
- Never clean the unit with water or any other liquid, this can cause electrocu-
tion.
- When the power cord is damaged it must be repaired or replaced by the after
60