Publicité
Les langues disponibles
Les langues disponibles
c) Inserting/changing the batteries
Two 1.5V batteries (AAA. LR03 Micro) are required to operate the measuring device. At initial
start-up or when the battery change symbol appears in the display, two new, fully charged bat-
teries must be inserted.
Proceed as follows to insert/replace the battery:
•
Disconnect the connected test leads from the measuring circuit and from the measuring
device. Power the multimeter off.
•
Loosen the rear screw on the battery compartment (7) and carefully pull the battery compart-
ment lid off the measuring device.
•
Insert a new battery with correct polarity into the battery insert of the measuring device.
•
Slide the battery compartment cover into the DMM and close the housing carefully.
Never use the measuring device when the battery/fuse compartment is open.
FATAL HAZARD!
Do not leave flat batteries in the device. Even batteries protected against leak-
ing can corrode and thus release chemicals which may be detrimental to your
health or destroy the device.
Do not leave batteries unattended. They may be swallowed by children or pets.
Seek immediate medical attention if a battery is swallowed.
If you do not plan to use the meter for an extended period, remove the battery
to prevent it from leaking.
Leaking or damaged batteries may cause acid burns if they come into contact
with your skin.
Always use protective gloves when handling leaking or damaged batteries.
Ensure that the batteries are not short-circuited. Do not throw batteries into
fire!
Batteries (non-storage) must not be recharged. There is a risk of explosion.
Only use alkaline batteries, as alkaline batteries are more powerful and have a longer
lifespan.
36
Publicité
