Troubleshooting - Soehnle Professional 3010 Mode D'emploi

10. Troubleshooting

Display
-0-
_____
-----
Err 04
Err 05
Err 06
Err 07
Err 08
Contact your Soehnle Industrial Solutions service partner if the malfunction is not remedied
or other error messages are displayed.
Description
The scale sets the value zero
automatically when it is swit-
ched on. If the scale is outsi-
de the set tolerance band, the
display indicates -0-.
Underload: Only the lower
horizontal lines appear in the
display.
Overload: Only the upper
horizontal lines appear in
the display. The maximum
weighing range is exceeded.
Part weight too small.
Zeroing limit overshot or
undershot.
Not possible to tare while the
scale is in an underloaded or
overloaded condition.
Not possible to print while the
scale is in an underloaded or
overloaded condition.
Switchover between units
is locked.
Remedy
Unload the scale. Possibly
remove any soiling. If the scale
fails to display zero after a few
seconds, please inform your
Soehnle Industrial Solutions-
service partner.
Switch off the scale and
switch it back on again. The
zero point will be reset auto-
matically.
Remove part of the weighing
product from the scale.
10
53