Application Programs; Weighing And Taring; Counting - Soehnle Professional 3010 Mode D'emploi

9.

Application Programs

The various application programs on the Terminal 3010 offer you a wide range of sulutions for weighing
operations. You can modify the application programs to your specific requirements in the setting mode
(see separate description 470.702.119 User Mode).
Below is a list of application programs available to you:

9.1 Weighing and taring

9.2 Counting

9.3 Totalising
9.4 Batching
9.5 Withdrawal weighing
9.6 Switching point programming
9.7 Checking
9.8 Count Checking
9.9 Dosing
9.1 Weighing and taring
Weighing
The appliance starts in weighing mode after power-on.
Place weighing product on platform and read the weight.
Weighing with tare
Refer to chapter 7.3.
NET
An active tare weight is indicated by the symbol „NET" appearing in the display.
9.2 Counting
The counting function is activated by pressing the Counting key.
The message „Add XXX" (XXX = No. of reference parts) requests you to place
one or several reference parts on the platform. By pressing the Counting key
repeatedly, you can change the reference quantity for lightweight reference
parts in steps of 1/2/5/10/25/50.
Place the reference parts on the platform and confirm by pressing the Print key.
Then place the countable parts on the platform and read off the amount.
Change to Weighing mode by pressing the Clear key.
Counting with tare
Refer to Chapter 7.3.
NET
An active tare weight is indicated by the symbol „Net" appearing in the display.
Displaying piece weight
Press the Info key and then the Counting key to display the piece weight.
Press the Clear key to return to weighing mode.
46