Cristec C.P.S. 960-1A Documentation page 30

CRISTEC
3.5 Commissioning
This section lists the operations to be performed in order to commission the charger.
It is advisable to comply strictly with these instructions before switching on for the
first time.
3.5.1. Selecting the mains supply voltage
Selection of the input mains supply is made using the selector outside the metal
case.
Precautions to be taken in using this selector are as follows:
The rating of circuit breakers placed on the supply side of the charger
must correspond with the latter's requirement.
There must be no ac voltage present when the selector is moved.
Position the voltage selector as a function of the type of alternating
mains supply used.
If this selector is incorrectly set irreversible damage to the charger may occur.
3.5.2. Selecting battery type
Drawings in appendix show the position of the potentiometer as a function of
the type of battery used.
You MUST check the compatibility of the selection and the type of battery
connected BEFORE you switch on.
3.5.3. Selecting charge mode
Drawings in appendix show the position of the selector as a function of the
type of charge used.
Precautions to be taken in using this selector are as follows:
You MUST check the compatibility of the "BOOST ON" mode voltage
with the type of battery connected.
During the winter period, or periods of prolonged charger connection to
the batteries, if the charger remains switched on set the switch to
"BOOST OFF" as a matter of course.
If using the "BOOST ON" function, the starter motor battery MUST be
connected to BAT D on models having 3 outputs.
If the charger is supplying 1, 2 or 3 banks of batteries with a low rate of
discharge, you are advised to select the "BOOST OFF" mode.
CPS960DEA
Page 30