Publicité
Les langues disponibles
Les langues disponibles
If any component should be missing, please contact your dealer.
Liquid Crystal Display Monitor: 1
Remote control unit: 1
Cable clamp: 2
Power cord: 1
R-6 battery ("AA" size): 2
CD-ROM (Utility Disk for Windows): 1
Setup Manual (this manual): 1
* Sharp Corporation holds authorship rights to the Utility Disk program. Do not reproduce it without permission.
* For environmental protection!
Do not dispose of batteries in household waste. Follow the disposal instructions for your area.
Preparing the Remote Control Unit and the Touch Pen
Installing the batteries
1. Press the cover gently and slide it in the direction of the
arrow.
2. See the instructions in the compartment and put in the
supplied batteries (R-6 ("AA" size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.
Supplied Components
Touch pen: 1
Pen tip (for touch pen): 2
Touch pen battery
(LR-03 ("AAA" size)): 1
USB cable: 1
Eraser: 1
Tray: 1
Inserting the battery
1. Rotate the battery cap and remove it, and then pull out the
2. Insert the supplied battery (LR-03 ("AAA" size)) in the
Tray mounting fitting (cover / bracket): x 2
Tray mounting screws: M5 x 4 / M4 x 2
Terminal label: 1
Used when installing the interface
expansion board PN-ZB01 (optional).
Cover Sharp logo: 1
Place this sticker onto the SHARP logo to
cover the logo.
cover.
orientation shown, and attach the cover and battery cap.
Battery cap
5
E
Publicité
