Télécharger Imprimer la page

Hilti NURON SSH 6-22 Mode D'emploi Original page 19

Publicité

Les langues disponibles

Les langues disponibles

▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9
Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See the section headed Status
indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, contact Hilti Service.
Trouble or fault
The battery runs down more
quickly than usual.
The battery does not engage
with an audible click.
The product or battery gets
very hot.
The motor has no braking
effect.
Product does not develop full
power.
Diminishing cutting perfor-
mance
LEDs of the battery show
nothing
10
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11
Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
*2331869*
Possible cause
Very low ambient temperature.
The retaining lug on the battery is
dirty.
Electrical fault
Battery is discharged.
Product is momentarily
overloaded.
A battery with inadequate capacity
was used.
Blade and / or cutting rails are
blunt.
Battery defective.
2331869
Action to be taken
▶ Allow the battery to warm up
slowly to room temperature.
▶ Clean the retaining lug and
re-insert the battery.
▶ Switch the product off immedi-
ately, remove the battery, keep
it under observation, allow it
to cool down and contact Hilti
Service.
▶ Change the battery and charge
the empty battery.
▶ Switch the product off and then
on again.
▶ Use a battery with adequate
capacity.
▶ Change the blade. → page 10
▶ Change the cutting rails.
→ page 10
▶ Contact Hilti Service.
English
13

Publicité

loading