Hilti NURON SSH 6-22 Mode D'emploi Original page 12

3 Description
3.1 Product overview
3.2 Intended use
The product described is a hand-held, cordless slitting shear. It is designed for cutting sheet-like workpieces
out of steel, aluminum, plastic or comparable materials. It can be used to cut along a marked line, for cutting
straight or curved outside edges and for cut-outs. The strip of swarf can be cut off at any point on the
workpiece.
• For this product, use only Hilti Nuron lithium-ion batteries of the B 22 series. For optimum performance,
Hilti recommends the batteries stated in the table at the end of these operating instructions for this
product.
For these batteries, use only Hilti chargers of the type series stated in the table at the end of these
•
operating instructions.
3.3 Items supplied
Slitting shear, Torx wrench, operating instructions
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Store or online at: www.hilti.group
Before being dispatched, the product was tested to ensure that it is in full working order. There
workpiece used in testing might have left tiny scratches in the surface of the housing.
3.4 Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the product's performance
drops noticeably or it might stall completely.
If the product stalls or slows significantly due to overloading, relieve the pressure applied to the product and
then allow it to run under no load for approx. 30 seconds.
3.5 Status indicators of the Li­ion battery
Hilti Nuron Li-ion batteries can indicate state of charge, fault messages and the battery's state of health.
3.5.1 Indicators for state of charge and fault messages
WARNING
Risk of injury by a falling battery!
▶ If the release button is pressed with a battery inserted in the product, subsequently check that the battery
is correctly re-engaged and secure.
6 English
1
Swarf cutter
@
Lockable on/off switch
;
Grip
=
Adjusting knob for speed
%
Battery status indicator
&
Battery release button
(
Battery
)
Dust filter
+
Bearing pin
§
Blade
/
Cut-off plate
:
Mark for swarf cut-off
∙
2331869
*2331869*