Publicité
Les langues disponibles
Les langues disponibles
10
FIGURE 11
Similarly, position the lower chimney section and fix the lower part to the frame using the 2 screws
FIGURE 11
removed previously.
11
FIGURE 12
FIGURE 12
attach the UPPER CHIMNEY
attaches using two screws
COVER.
provided (G in FIGURE 13).
Install the LOWER CHIMNEY
2. Attach the duct work to the
COVER by sliding it up over
DAMPER (M in FIGURE 1).
the support and the UPPER
Make sure to seal all joints with
CHIMNEY COVER.
duct tape to prevent leaks.
For ductless installations, line up the DUCTLESS DIVERTE
3. The LOWER CHIMNEY
EXTENSIONS HORIZONTAL (B in FIGURE 12) with the hol
COVER (B in FIGURE 13)
in the LOWER CHIMNEY COVER (D in FIGURE 12) and sna
attaches using two screws
in the VENT GRIDS (C in FIGURE 12).
provided (G in FIGURE 13).
Install the LOWER CHIMNEY
COVER by sliding it up over
the support and the UPPER
CHIMNEY COVER.
For ductless installations, line up the DUCTLESS DIVERTER
EXTENSIONS HORIZONTAL (B in FIGURE 12) with the holes
in the LOWER CHIMNEY COVER (D in FIGURE 12) and snap
in the VENT GRIDS (C in FIGURE 12).
Only For Ductless Installations
Ductless installations require a Ductless
Conversion Kit whose components
are pictured in FIGURE. Do not use the
DAMPER for ductless installations.
Insert the Connector extensions B into the
side of the Connector A.
Insert the Connector A into the Support
bracket C and fix it with the screws.
Fasten the Support bracket C, fixing it to the
upper part with the Screws.
Make sure that the Connector extensions
outlet B is in correspondence with the
Chimney openings both horizontally and
vertically.
FIGURE 13
FIGURE 13
Version 02/12 - Pag
12
Publicité
