Velleman SG21006 Notice D'emploi page 5

The unit will enter an alarm status when connecting to the power supply. The message "ARM st" or "DISARM
st" will be displayed. To enter the programming mode or the settings, activate the DISARM mode first.
b. Deactivating the alarm system (DISARM)
Deactivate the alarm system (DISARM) by entering the user code.
Example:
The "DISARM st" message will be displayed and you will hear the vocal message "System disarmed". Note
that the system will not react to an intrusion trigger signal. It will only react to a SMOKE, GAS or PANIC signal
(24h-alarm).
c. Activating the alarm system
There are two ways to activate the alarm system.
1. AWAY activation:
The system reacts to all connected and programmed sensors. The message "ARM st" will be displayed and
you will hear the vocal message "System armed". Activate the system by pressing the AWAY button.
2. HOME activation:
This mode will only secure programmed zones while other will not be covered by the system. This allows
the user to freely access some zones without triggering the alarm. The message "GUARD st" will be
displayed and the vocal message "System armed" will be heard. Activate the system by pressing the
HOME button.
REMARK: Sensors programmed for fire, gas or panic detection (24h-function) will remain activated, even
when the system is in DISARM mode.
d. Entering the programming mode
To enter the programming mode, put the central unit in DISARM mode first and press the SET button. The
message "INPUT LEVEL" will be displayed. Enter the system code (6 characters), followed by a press of the #
button to confirm.
Example:
The programming menu will be displayed.
HAM06WS_v2
1 2
0 0
3 4
SET
Input Level
0 0
1,Sys 2,Zone
3,Setup 4,study
5
0 0 #
VELLEMAN