Klipsch R-40PM Mode D'emploi page 25

EU COMPLIANCE INFORMATION
Eligible to bear the CE mark; Conforms to Eu-
ropean Union Low Voltage Directive 2006/95/
EC; European Union EMC Directive 2004/108/
EC; European Union Restriction of Hazardous
Substances Recast (RoHS2) Directive 2011/65/
EC; European Union WEEE Directive 2002/96/
EC; European Union Eco-Design Directive
2009/125/EC; European Union Registration,
Evaluation, Authorization and Restriction of
Chemicals (REACH) Directive 2006/121/EC;
European Union Radio and Telecommunica-
tions Terminal Equipment (R&TTE) Directive
1999/5/EC.
This product contains batteries that are
covered under the 2006/66/EC European
Directive, which cannot be disposed of with
normal household waste. Please follow local
regulations.
You may obtain a free copy of the Declara-
tion of Conformity by contacting your dealer,
distributor, or Klipsch Group, Inc.'s worldwide
headquarters. Contact information can be
found here: http://www.klipsch.com/Contact-Us
WEEE NOTICE
Note: This mark applies only to countries
within the European Union (EU) and
Norway.
This appliance is labeled in accordance with
European Directive 2002/96/EC concerning
waste of electrical and electronic equipment
(WEEE). This label indicates that this product
should not be disposed of with household
waste. It should be deposited at an appropriate
facility to enable recovery and recycling.
FCC AND CANADA EMC COMPLIANCE
INFORMATION
This device complies with Industry Canada's
licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference,
including interference that may cause undesired
operation of the device.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equip-
ment and receiver.
• Connect the equipment into an outlet on a cir-
cuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
Approved under the verification provision of
FCC Part 15 as a Class B Digital Device.
Caution: Changes or modifications not express-
ly approved by the manufacturer could void the
user's authority to operate this device.
Caution: To comply with the limits of the Class
B digital device, pursuant to Part 15 of the
FCC Rules, this device is to comply with Class
B limits. All peripherals must be shielded
and grounded. Operation with non-certified
peripherals or non-shielded cables my result in
interference to radio or reception.
This Class B digital apparatus complies with Ca-
nadian ICES-003. CAN ICES-3 (B)/NMB-3(B) Cet
appareil numérique de la classe B est conforme
à la norme NMB-003 du Canada.
WIRELESS TRANSMITTER COMPLIANCE
INFORMATION
The term "IC:" before the radio certification
number only signifies that Industry Canada
technical specifications were met.
Le terme «IC:» avant le numéro de certi-
fication radio signifie seulement que les
spécifications techniques d'Industrie Canada
ont été respectées.
This device complies with part 15 of the FCC
Rules and the applicable Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause harmful interference,
and (2) this device must accept any interfer-
ence, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
This equipment complies with FCC and IC ra-
diation exposure limits set forth for an uncon-
trolled environment. This equipment should be
installed and operated with minimum distance
20cm between the radiator and your body.
This transmitter must not be co-located or op-
erating in conjunction with any other antenna
or transmitter.
Cet appareil est conforme à FCC et IC l'expo-
sition aux rayonnements limites fixées pour
un environnement non contrôlé. Cet appareil
doit être installé et utilisé avec une distance
minimale de 20 cm entre le radiateur et votre
corps. Cet transmetteur ne doit pas être co-
situé ou opérant en liaison avec toute autre
antenne ou transmetteur.