Product Information; Concerns On Installation - Graco SNUGRIDE i-SIZE BASE Manuel Du Propriétaire

child harness when the child is
placed in infant carrier module,
even when the enhanced child
restraint is not in the vehicle.
Before carrying the infant carrier
module by hand, ensure that the
child is fastened with the child
harness, and that the handle
is correctly locked in a vertical
position.
To avoid serious injury or death,
NEVER place infant carrier module
on elevated surface seat with child
in it.
The parts of this enhanced child
restraint should not be lubricated
in any way.
Always secure child in enhanced
child restraint, even on short trips,
as this is when most accidents
occur.
Please keep this enhanced child
restraint away from sunlight,
because it may be too hot for
child's skin. Always touch the
enhanced child restraint before
placing child in it.
13
Product
Information
"i-Size" (Integral Universal ISOFIX
Enhanced Child Restraint Systems)
is a category of Enhanced Child
Restraint System for use in all i-Size
seating position of a vehicle.
1.
According to the ECE R129/02
Regulation, the product is a
Universal ISOFIX Class ISO/
R2 enhanced child restraint
and should be fitted using the
ISOFIX connections.
2.
This is an "i-Size" Enhanced
Child Restraint System. It
is approved according to
Regulation No.129, for use
in, i-Size compatible vehicle
seating positions as indicated
by vehicle manufacturers in
the vehicle users' manual.
3.
If in doubt, consult either
the Enhanced Child Restraint
System manufacturer or the
retailer.
It is approved to ECE R129/02
series of amendments, not all
vehicle manufacture's handbooks
list i-Size compatibility yet. This
seat and base is also approved
for use in ISOFIX compatible
vehicles. Please refer to the vehicle
manufacturer's website or consult
your dealer.
It will fit vehicles with positions
approved as i-Size ISOFIX positions
(as detailed in the vehicle
handbook), depending on the
category of the enhanced child
restraint and of the fixture.
Concerns on
Installation
1 3
See images -
1
DO NOT install this enhanced
child restraint on vehicle seats
that face sideways or rearward
with respect to the moving
direction of the vehicle.
It is recommended to install
this enhanced child restraint
on the rear vehicle seat.
DO NOT install this enhanced
child restraint on vehicle seats
movable during installation.
2
DO NOT place rear-facing
14
enhanced child restraint
on front seat with air bag,
because death or serious
injury may occur. Please
reference vehicle owner' s
manual for more information.
3
This infant carrier is suitable
for vehicle seats with i-Size
ISOFIX anchor points with the
Base.
Handle
Adjustment
4
See image
4
To adjust the handle, squeeze
the handle buttons on both
sides to release it , and then
rotate the handle until it clicks
into any of the 4 positions.
The handle of the infant
carrier module can be
adjusted to 4 positions.
Position A - Position for car,
hand or stroller transportation.
Position B&C - Rocking
position.
Position D - Baby chair
position.