Care And Maintenance - Graco SNUGRIDE i-SIZE BASE Manuel Du Propriétaire

26
This infant carrier module is
suitable for vehicle seats with
a 3-point retractor safety belt
only.
27
Place the infant carrier
module onto the vehicle seat
where you wish to put it.
28
Pull the vehicle safety belt out
and lock it into the vehicle
buckle, sliding the vehicle lap
belt into the side guides of
the infant carrier module.
29
Slide diagonal belt into the
rear guide.
The infant carrier module
can not be used if the vehicle
safety belt buckle (female
buckle end) is too long to
anchor the infant carrier
module securely.
30
Pull the vehicle shoulder belt
to fasten the infant carrier
module tightly and securely.
17
Detaching
Seat Pad
31 32
See images -
To re-assemble the soft goods,
reverse the aforementioned steps.
Care and
Maintenance
33 34
See images -
Wash the seat cover and inner
padding with cold water
(temperature below 30°C).
Do not iron the soft goods.
Do not bleach or dry clean the soft
goods.
Do not use undiluted detergents,
gasoline or other organic solvent
to wash the infant carrier module.
It may cause damage to the
enhanced child restraint.
Do not twist the seat cover and
inner padding in an attempt to
dry. It may leave the seat cover and
inner padding with wrinkles.
Hang dry the seat cover and inner
padding in the shade.
Remove the enhanced child
restraint from the vehicle seat if it
is not going to be used for a long
period of time. Put the enhanced
child restraint in a cool, dry place
and somewhere your child cannot
access it.
Store the instruction manual in
the slot where the manual icon is
shown. To purchase replacement
parts or accessories, please contact
us at the following:
www.gracobaby.eu
www.graco.co.uk
www.gracobaby.pl
18