Monacor AXZ-204BVM Mode D'emploi page 53

7.8 Controlling a PTZ camera
When one or more cameras are connected that can be
remote-controlled (pan, tilt, zoom, focus etc.), they may be
conveniently controlled by means of the recorder.
1) Use the left mouse button to click the live image of the
camera to be controlled. (In the single-image mode, simply
press the left mouse button.) The quick-selection bar will
appear:
Fig. 7-19 Quick-selection bar
2) Click the symbol . The control window will appear:
CH1 SPEED
– +
ZOOM
– +
FOCUS
– +
IRIS
Fig. 7-20 Window for PTZ control
Menu item
Function
Symbol
CH... To select the camera channel
To pan, tilt,
arrows

to pan and tilt at the same time
To enable / disable the automatic panorama pan
function
SPEED
Pan / Tilt speed
To start / stop the camera cruise
To call up the window for saving camera posi-

tions for the camera cruise feature
ZOOM Zoom function
FOCUS To adjust the focus
IRIS To adjust the iris
3) To exit the control window, click the image with the right
mouse button.
7.9 Deleting data
When you want to dispose of the recorder or plan to give
(e. g. sell or lend) it to a third party, make sure to delete all
recordings and passwords: Format the hard disk and reset the
recorder to its factory settings. Otherwise, you will pass on your
recordings, personal data and passwords with the recorder.
1) Call up the main menu. Either press the button MENU at
the recorder/on the remote control
or use the mouse:
To call up the toolbar, press the right mouse button or
move the mouse pointer to the centre of the lower edge
of the screen.
Fig. 7-21 Toolbar
In the toolbar, click the symbol
20
"Main Menu" to the left.
Parameter Record Search Device
Display
Channel
Analog Channels
CH1
IP Channels
CH2
CH3
Live
CH4
Output
Image Control
Analog Channels
Privacy Zone
Record
Capture
Network
Alarm
Fig. 7-22 Main menu
2) In the bar located at the top of the menu, click "Device".
Parameter Record Search Device
HDD
No. State
PTZ
1* OK
Cloud
Overwrite Auto
Fig. 7-23 Menu "Device", submenu "HDD"
3) Select the hard disk: In the column "Select", click the row
with the hard disk (see mouse pointer in the figure above).
4) Click the button "Format HDD". The window "Login"
will appear:
Parameter Record Search Device
HDD
No. State
PTZ
1* OK
Cloud
User
Password
Overwrite Auto
Fig. 7-24 Window "Login"
5) When a password has been defined, enter the password.
Click "Login". The following confirmation window will
appear:
Notice
Entire Data Will Be Erased. Do You Want To
Continue?
OK Cancel
Fig. 7-25 Window for confirming formatting
6) Click the button "OK". A status bar will appear, indicating
the formatting progress. When formatting has been com-
pleted, the following message will appear:
Notice
Format Completed
100%
OK
Fig. 7-26 Hard disk formatted
7) Click "OK": The available capacity and the available
recording time will be shown.
8) To delete all passwords and other data, reset the recorder
(see next chapter).
i
System Advanced
Channel Name State
CH1 Enable
CH2 Enable
CH3 Enable
CH4 Enable
CH1 CH2 CH3 CH4
Save
i
System Advance
Free/Total Free Time
891G/931G 202STD
Format HDD
Default Save
i
System Advanced
Free/Total Free Time
891G/931G 202Hour
Login
I a dmin
Login Cancel
Format HDD
Default Save
Shutdown
Cancel
Shutdown
Select
Cancel
Shutdown
Select
Cancel
53