JB Systems Light ATLAS Mode D'emploi page 5

ENGLISH
4. Controlled by universal DMX-controller:
When the units are connected in DMX-mode, they can be controlled using the following DMX-charts:
1 CHANNEL MODE
What are patterns?
Patterns are different static (non moving) combinations of LEDs.
When the value of CH1 is set between 000 and 119, you can use CH2 to select 25 different patterns.
Use CH3 to change the strobe frequency of the selected patterns.
What are chases?
Chases are a series of patterns put in a loop to create dynamic (moving) effects.
When the value of CH1 is set between 120 and 239, you can use CH2 to select 25 different chases.
Use CH3 to change the speed of the selected chases.
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
 Clean the external optics at least once every 30 days.
 Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
JB SYSTEMS
®
OPERATION MANUAL
4 CHANNEL MODE
5/36
ENGLISH
SPECIFICATIONS
Mains Input:
Fuse:
Sound Control:
DMX connections:
DMX channels used:
Lamp:
Size:
Weight:
You can download the latest version of this user manual on our website: www.beglec.com
ATLAS JB SYSTEMS
AC 100V ~ 240V, 50/60Hz
250V 2A slow blow (20mm glass)
Internal microphone
3pin XLR male / female
1 or 4 channels
52 LEDs (R=16 + G=12 + B=12 + W=12)
236 x 141 x 203 mm
2kg
Every information is subject to change without prior notice
6/36
®
OPERATION MANUAL
ATLAS