Replacing Cutting Knife; Replacing Matrice And Die - Orgapack 5000 Série Mode D'emploi

ORGAPACK CH 48

6.5 REPLACING CUTTING KNIFE

If the strap is only partly cut off or not at all,
the cutting knife must be replaced.
Removal
– Remove the four shoulder screws (12/6) and (12/5).
– Draw out cover with sealing lever (12/4).
– Raise rocker lever (12/1) and raise sealing block
(12/7) slightly in housing and remove.
– Release two countersunk screws (12/2) and remove
and replace cutting knife (12/3).
– Clean and grease sealing block (12/7).
Installation
– Install the parts in reverse order.
– Set cut-off depth after assembly (see chapter 6.2).

6.6 REPLACING MATRICE AND DIE

If the seal is no longer properly notched (seal
does not grip), the matrice and the die must
be checked and replaced if necessary.
Removal
– Remove sealing block (13/6) (see chapter 6.5).
– Remove two cylinder screws (13/4) in each case,
remove and replace left and right matrice (13/5),
(13/3).
– Remove two cylinder screws (13/1) and remove
and replace die (13/2).
Installation
– Install the parts in reverse order.
Mount new cylinder screws (13/1) and (13/4)
(secure screws with Loctite 243).
22
7
6
5
Fig. 12
6
3
5
4
Fig. 13
3
2
4
2
1
05.03/WE
1
1