Domo DO603ED Mode D'emploi page 23

DO603ED
KEEP THESE INSTRUCTIONS FOR LATER REFERENCE.
6
PARTS
1. Warning label and type plate
5
2. Blanket connection
3. Lead connection
4. Electric lead
5. Electronic control unit
4
2 1
3
6. Loop for fastening ribbon
CONTROL
1. On/off switch 2
6
2. Start/stop button
1
5
3. Function button (mode)
4
3
4. "+" and "-" button
5. Timer button
6. Preheat button
INSTRUCTIONS FOR USE
Plug the electrical connector into the blanket's electrical fixture.
Plug the devise into the socket.
Adjust the regulator at the side of the control unit to the "1" position.
Press the "mode" button to set the temperature of the blanket. Press the "+" or "-"
buttons. You can make a selection from "1" to "8" for the different temperature
settings. "1" is the lowest temperature and "8" is the highest temperature. Select
"foot" if you wish to heat only the foot end of the blanket.
TAKE CARE: temperature selection "8" is the highest temperature setting. This
setting is used only to quickly preheat the blanket. After 30 minutes this setting will
automatically set itself to position "3".
Press the "timer" button to adjust the length of time you wish to heat the blanket. Use
the "+" and "-" button to set the time from 1 min to 12 hours.
Press the "preheat" button to preset the time for start heating. Use the "+" and "-"
button to set the length of time you wish to start preheat, between 1 minute to 19:59 h.
We recommend to preheat the unit on position "7" or "8". This setting cannot be used
for sleeping on . For heating during sleeping set to position "3,4 or 5" to your deisred
comfort temperature.
After completing all of the settings mentioned above, press the "start/stop" key to
switch the heated blanket on. Press the "start/stop" key again in order to switch the
devise off.
Note: When using the devise for the first time a light odour may be detectable. This is
normal and is caused through the use of new materials. The odour will vanish quickly.
23