Elem Garden Technic TTAC58T43R-CC196 Traduction Des Instructions D'origine page 61

To replace the blade, undo the screw.Empty the oil tank before removing the blade
Reinstall as illustrated. Tighten the screw properly. Tightening torque 40 Nm. When replacing the blade, the blade
screw should also be replaced. to run briefly.
• Clean the air filter according to the directions.
• When, after many years of service, your machine needs to be replaced or is no longer required, we
recommended that the machine is returned to your distributor for recycling.
• check the grass catcher frequently for wear or deterioration
SERVICING
Genuine spare parts are supplied by service workshops and by many dealers. We recommend that you take the
machine to an authorized service station for annual servicing, maintenance and inspection of safety equipment. For
service and spare parts, please contact the dealer where the machine was purchased.
The noise test code is EN 3744 Engineering method (grade 2)
The vibration test code is EN 1033 for hand push type mower.
Engine Maintenance
Check Engine Oil Level
Check the engine oil level with the engine stopped and the mower.
Remove the oil filler cap, and wipe the dipstick clean.
Insert the dipstick into the oil filler neck, but do not screw it in.
Check the oil level shown on the dipstick. If near the lower, fill to the upper level with the oil. Do not
overfill.
Screw in the filler cap securely.
Oil tank : 0.6L SAE 10W-30
61