Publicité
CAUTION
Plug the connecter firmly into the receiver.
«Don't cut and bundle the antenna of the receiver. Ensure it is fully extended.
• Ве careful the receiver doesn't get waste or fuel from engine cars.
• || is recommended to wrap the receiver in sponge in the engine to avoid vibration.
eif electric car, use double-sided tape for attaching the receiver/servos.
«Ensure that the pipe which holds up the antenna is located near to the receiver.
• Џѕе plastic antenna pipe and stand to ensure the antenna stands upright.
«High frequency speed controllers can suffer from interference from Ni-cd or motor wire, keep the antenna
away as far as possible from them.
* We recommend a noise killer condenser on a motor.
„Ме а! and carbon chassis cause noise from electric conductivity, therefore, keep the antenna of the receiver
away from chassis.
|
«Use TX-antenna as full length not half way. Always fully extend TX antenna.
eCheck polarity of batteries following the indication on the battery box and make sure they are installed the
right way.
e Avoid contact with water and this equipment.
SPECIFICATION
TRANSMITTER
OPERATION SYSTEM
WHEEL+TRIGGER
CONTROL CPU
8 bit MICROPROCESSER
DATA MEMORY
EEPROM ANTI-VOLATILITY MEMORY
FREQUENCY
27MHz, 40MHz ог 75MHz
MODULATION SYSTEM
AM, FM
POWER SUPPLY
12V(R6[AA] x 8)or 9.6V(Ni-cd battery X 8)
ANTENNA OUTPUT
100mA
Publicité
