Publicité
Les langues disponibles
Les langues disponibles
Inserting/changing the remote control batteries
NOTE
►
The supplied battery (type CR2025) is already installed in the remote control
on delivery. Before use remove the insulation strip from the battery compartment.
To replace the battery proceed as follows:
♦
Pull the battery compartment out of the remote control
pressing in the catch at the side and, at the same time, pulling
the battery compartment out.
♦
Remove the depleted battery and insert a new battery of the
type CR2025 (button cell) into the battery compartment.
Be sure to insert the battery according to the polarity (the plus
sign must point upwards).
♦
Slide the battery compartment back into the remote control
place.
Charging the speaker
CAUTION
►
Charge the speaker
♦
Remove the rubber cover
speaker
.
♦
Connect the USB plug of the charger cable
the other end of the charger cable
♦
Plug the mains adapter
the speaker lights up red and the battery will be charged. As soon as the red light
goes off, the integrated battery is fully charged.
♦
Pull the charger cable
cover
.
NOTE
►
The charging time is approximately 5 hours with a charging current of 1 A and
allows music playback of up to 5 hours at a medium volume. The playback
time may vary depending on usage (volume/lighting).
►
When the battery is depleted, the speaker flashes red for about 10 seconds
and switches off.
│
GB │ IE
■
24
only in dry interior spaces.
from the charger socket
to the mains adapter
to the speaker charging socket
into a properly installed power socket. The lower part of
out of the charging socket
by
until it locks into
on the underside of the
and connect
.
and replace the rubber
SBLF 5 A1
Publicité
