Pioneer PREMIER SUPER TUNER III D DEH-P980BT Mode D'emploi page 81

Audio Adjustments
Fader (balance adjustment) Position (posi-
tion selector) TA Mode (time alignment set-
ting) Time Alignment (time alignment
adjusting) Loudness (loudness) Powerful
(graphic equalizer adjustment) FREQ. (16-
band graphic equalizer adjustment)
Subwoofer1 (subwoofer on/off)
Subwoofer2 (subwoofer cut-off frequency)
Subwoofer3 (subwoofer slope) Front HPF
(front high pass filter slope)
Front HPF FREQ. (front high pass filter cut-off
frequency) Rear HPF (rear high pass filter
slope) Rear HPF FREQ. (rear high pass filter
cut-off frequency) BBE (BBE) COMP/BMX
(Compression and BMX) Auto EQ (auto-
equalizer on/off) SLA (source level adjust-
ment) AUI sound level (auditory user inter-
face)
When selecting OFF in TA Mode, you cannot
switch to Time Alignment.
You can select Subwoofer2 and
Subwoofer3 only when subwoofer output is
turned on in Subwoofer1.
When tuner, television or AUX is selected as a
source, you cannot select COMP/BMX.
When selecting the FM tuner as the source,
you cannot switch to SLA.
To return to the display of each source, press
BAND.
Note
If you do not operate the audio function within
about 30 seconds, the display is automatically re-
turned to the source display.
Black plate (81,1)
Using the position selector
One way to assure a more natural sound is to
clearly position the stereo image, putting you
right in the center of the sound field. The posi-
tion selector function lets you automatically
adjust the speakers output levels and inserts
a delay time to match the number and posi-
tion of occupied seats.
1 Use MULTI-CONTROL to select Position.
Position appears in the display.
2 Push MULTI-CONTROL left, right, up or
down to select a listening position.
Direction Display Position
Front Left
Left Front seat left
Front Right
Right Front seat right
Up Front Front seats
Down All All seats
To cancel the selected listening position, push
MULTI-CONTROL in the same direction again.
Using balance adjustment
You can change the fader/balance setting so
that it can provide you an ideal listening envir-
onment in all occupied seats.
1 Use MULTI-CONTROL to select Fader.
Fader appears in the display.
If the balance setting has been previously ad-
justed, Balance will be displayed.
2 Push MULTI-CONTROL up or down to
adjust front/rear speaker balance.
Each time MULTI-CONTROL is pushed up or
down, the front/rear speaker balance moves
towards the front or rear.
<CRD4096-A/N>81
Section
15
81
En