Pioneer PREMIER SUPER TUNER III D DEH-P980BT Mode D'emploi page 19

Tuner
Listening to the radio
1 1 1 2 2 2 2
6 6 6
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
1 Stereo (
) indicator
Shows when the selected frequency is
being broadcast in stereo.
2 LOC indicator
Shows when local seek tuning is on.
3 Band indicator
Shows which band the radio is tuned to, AM
or FM.
4 Preset number indicator
Shows which preset has been selected.
5 Frequency indicator
Shows the frequency to which the tuner is
tuned.
6 Signal level indicator
Shows the radio wave strength.
1 Press SOURCE to select the tuner.
Press SOURCE until you see Tuner displayed.
2 Press BAND to select a band.
Press BAND until the desired band (FM-1,
FM-2, FM-3 for FM or AM) is displayed.
3
MULTI-CONTROL left or right.
The frequencies move up or down step by
3 3 3 3 4 4 4 4 5 5 5 5
step.
4
MULTI-CONTROL left or right for about one
second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
MULTI-CONTROL left or right.
right you can skip stations. Seek tuning starts as
soon as you release MULTI-CONTROL.
Black plate (19,1)
To perform manual tuning, push
To perform seek tuning, push and hold
You can cancel seek tuning by pushing
If you push and hold MULTI-CONTROL left or
<CRD4096-A/N>19
Section
04
19
En