Charging The Device - Num'axes Eyenimal DIGITAL PET CLIPPER NGTON003 Guide D'utilisation

Charging the device

To charge the unit, connect the power cable from the AC adapter to device and connect the AC adapter
to a wall electric outlet.
During charging, the LCD digital display is lighting.
A complete charge takes approximately 3 hours and allows you up to 5 hours of use.
Before first use, be sure to fully charge the device.
Using the device connected to the mains
To use the device connected to the mains, connect it to the mains and wait a few seconds before
switching it on.
Battery LCD digital display indicator
When the device is on, the remaining time of use is indicated on the LCD digital display.
On / Off switch
Slide the On / Off switch to turn the device on and off. In the ON position, the device is ready for use.
To turn off the unit, slide the switch to the OFF position.
Adjusting the gap between the blades
The gap between the blades is set to 1.9 mm. To reduce it, slide up the adjustment button (Fig 1).
Press the button to return to the home position (Fig 2).
Mounting the comb
Place the comb into the notch in front of the clipper head.
Check that the comb is firmly engaged and securely attached to the device.
Select the comb you need according to the length you want:
- the small comb to cut the fur to a length of 3 to 6 mm.
- the big comb to cut the fur to a length of 9 to 12 mm.
9