Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
4.
Verify mounting screws are properly seated in mounting
slots in mount base.
5.
Move locking lever to "LOCKED" position. (See Figure 11)
6.
Insert key into lock and turn to secure projector to RPME.
7.
Route all cables, as required.
ADJUSTMENTS
The RPME projector mount can be adjusted for pitch (vertical
elevation), roll (horizontal tilt), and yaw (rotation).
WARNING:
OVER-LOOSENING OR REMOVAL OF
HARDWARE MAY RESULT IN PERSONAL INJURY OR
SERIOUS DAMAGE TO EQUIPMENT! RPMX projector
mount and hardware is to be loosened only enough to allow
for necessary movement.
YAW Adjustment (Rotation)
1.
Loosen YAW adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 12)
2.
Turn YAW micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3.
Tighten YAW adjustment locking screw using a #2 Phillips
screwdriver.
2
Figure 12
Pitch Adjustment (Vertical Elevation)
1.
Loosen PITCH adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 13)
2.
Turn PITCH micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3.
Tighten PITCH adjustment locking screw using a #2 Phillips
screwdriver.
1
3
2
2
Figure 13
Roll Adjustment (Horizontal Tilt)
1.
Loosen ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 14)
2.
Turn ROLL micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3.
Tighten ROLL adjustment locking screw using a #2 Phillips
screwdriver.
2
Figure 14
1
2
1
2
RPME
3
3
9
Publicité
Table des Matières
