Publicité
Les langues disponibles
Les langues disponibles
INTELLIGENT STEAM CONTROL
The Shark
Steam
®
Setting
Cleaner has 3 unique
Intelligent Steam
Control settings so
you can use the right
TOOLS
amount of steam for
the cleaning task at
hand.
See below for
tips on when to
use each setting.
LO
HI
Steam
Blaster
TO SANITIZE* WITH THE STEAM CLEANER USING THE
INTELLI-MOP HEAD AND THE DIRT GRIP PAD:
* Sanitisation studies
1 Attach a clean Dirt Grip pad to the mop head.
were conducted
2 Plug in the unit and press the Steam Control Button
under controlled
to select the HI Setting.
test conditions.
3 Wait 30 seconds for the unit to begin producing
Household conditions
steam.
and results may vary.
4 Start mopping on an appropriate sealed hard floor
With Klik N' Flip® Mop
surface with a forward and backward motion. After
in HI mode only when
three minutes, your unit is ready to be used to sanitize.
used with Steam
5 Using a forward and backward motion, move the
Cleaner.
unit over the area you seek to sanitize. Repeat at
Not in Steam Blaster
least 5 times.
mode.
11
s h a r kc l e a n . e u
Ideal For These
Recommended
Sealed Surfaces
Usage
Laminate
Cleaning delicate
surfaces.
Hardwood
Light cleaning and
Marble
dusting.
Loosening and
lifting light dirt.
Hardwood
Cleaning most
surfaces and large
Marble
areas.
Tile
Basic, everyday
cleaning.
Stone
Removing spots and
smaller messes.
Cleaning moderate
and heavy-traffic
areas.
Hardwood
Deep-cleaning and
cleaning hard-to-
Marble
clean surfaces.
Tile
Tough cleaning and
removing stuck-on
Stone
messes and stains.
Deep-cleaning
heavy-traffic areas.
Cutting through
heavy dirt
and grime.
Sanitizing* floors.
For an extra burst of steam, you can
use the Steam Blaster feature in LO or
HI. Follow the instructions found on the
"Using your Steam Cleaner" page.
ABOVE-FLOOR CLEANING
The Shark® Floor and Handheld Steam
For a full list of what
is included with your
Cleaner is designed to clean surfaces that can
Steam Cleaner, please
withstand high heat and moisture. Do not use
refer to box's top panel.
on unsealed wood surfaces (especially antique
wood furniture), unglazed ceramic tile, painted
surfaces, or surfaces that have been treated
with wax, oils, varnishes, or shellac. The sheen
may be removed by the heat, steam, and
friction of the cleaning accessories. It is always
recommended to test an isolated area of the
surface to be cleaned before proceeding.
We also recommend you check the use and
care instructions from the surface manufacturer.
When cleaning finished wood surfaces, use
broad, continuous strokes. To prevent surface
damage, avoid focusing steam or allowing the
cleaning accessories to remain stationary in any
one spot.
• Remove the Handheld Steamer by pressing
on the release button and pulling away from
the cradle.Be careful to NOT press the steam
trigger as you remove the handheld steamer.
(Fig. 12).
• The Handheld Steamer is automatically set
to TOOLS mode. Squeeze the steam trigger
to activate steam. You may select other
steam modes depending on the accessory
and the use.
• With all attachments, control Steam better by
using 3-to-5-second bursts of the trigger. This will
allow you to steam longer and with more control.
Fig. 12
12
s h a r kc l e a n . e u
Publicité
