Maytag PDT-1 Guide D'utilisation Et D'entretien page 6

Using the Controls - 6 Cycles Model
STEP 1
Select Temperature
To select the correct temperature, turn the temperature
control to one of four choices: Regular, Medium, Low
or Air Fluff.
DRYER TEMPS
Regular Sturdy cottons or labels marked
Tumble Dry.
For wrinkle-free/permanent press
Medium
synthetics, lightweight cottons or
items labeled Tumble Dry Medium.
Low For heat sensitive items labeled
Tumble Dry Low or Tumble Dry
Medium.
Air Fluff Items which need freshening.
Load tumbles with room
temperature air. Use the Time
Dry/Air Fluff cycle.
STEP 2
Select End of Cycle Signal
When the cycle is complete, a signal will sound. The
signal can be canceled by turning the switch to Off.
Remove load immediately to reduce wrinkling.
5
LOAD TYPE
STEP 3
Select Cycle
To select a cycle, rotate the control dial to the desired
setting. When using an Auto Dry cycle, the control dial
should point between More Dry and Less Dry for most
loads.
Loads of larger or bulkier size may require the More
Dry setting to completely dry the load. The Less Dry
setting is best suited for lightweight fabrics or for leaving
some moisture in the clothing at the end of the cycle.
Auto Dry Regular
The Auto Dry Regular cycle is designed to dry most
cottons and linens. At the end of the cycle, the clothes
are cooled for approximately 10 minutes to reduce
wrinkling.
Auto Dry Permanent Press
The Auto Dry Permanent Press cycle is designed to dry
wrinkle-free cottons, synthetic fabrics, double knits and
permanent press fabrics automatically. At the end of
the cycle, the clothes are cooled for approximately 10
minutes to reduce wrinkling.