Pando PLB-7161 Manuel D'installation page 223

Step 3. Dishwasher installation steps
Please refer to the Please refer to the specific installation steps in the installation
drawings. drawings.
1. Affix the condensation strip under the work surface of cabinet. Please ensure the
condensation strip is flush with edge of work surface. (Step 2)
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into
6. Level the dishwasher. The rear foot can be adjusted from the front of the
dishwasher by turning the
use a Philips screw
front feet until the dishwasher is level. (Step 5 to Step 6)
7. Install the furniture door to the outer door of the dishwasher. (Step 7 to Step 9)
8. The dishwasher must be secured in place. There are two ways to do this:
A. Normal work surface: Put the installation hook into the slot of the side plane and
secure it to the work surface with
B. Marble or granite work top: Fix the side with
A
B
specific installation steps in the installation
the cabinet .
Philips screw
driver . To adjust the front feet, use a flat screw driver and turn the
the screws.
52
in the middle of the base of dishwasher
screws .