Control Unit; Key Functions - Dimplex DX 410E Instructions De Montage Et D'utilisation

English
6. Control description
6.1

Control unit

The heating device is equipped with a configurable
electronic control, consisting of a display, a red LED
and five keys.
The control unit is located on the side on the right.
The set functions and values are shown on the display.
The LED lights up red when heating ON.
6.2

Key functions

MODE
Automatic mode (week program)
Manual operation ON
Manual operation OFF
ENTER
Save entry.
PROG
Week program, set clock.
Keys +/-
Used to navigate through the menu and to change the
setting values.
EN-3
7. Possible operating modes
7.1 Automatic operation
Up to four heating program (ON/OFF) can be set for
each weekday. A room temperature can be specified
for each heating program.
AUTO appears on the display.
7.2 Manual operation
Manual specification of the room temperature.
MANUAL ON or MANUAL OFF appears on the display.
7.3 ADVANCE
Switch to the next program item in automatic mode.
ADVANCE appears on the display.
NOTE NOTE
In manual operation (MANUAL ON), the room temper-
ature can be specified with the
In automatic mode, the room temperature setting is
only carried out for the current running time program.
8. Commissioning
8.1 Setting the time and week day
The time and day are set with the following steps:
Press and hold the PROG key for three seconds.
The clock symbol appears. The hours display
flashes.
Use the + / - keys to set the hours. Press the
ENTER key. The minutes display flashes.
Use the + / - keys to set the minutes. Press the
ENTER key. The weekday flashes.
Use the + / - keys to set the weekday. Press the
ENTER key. The CLOCK symbol disappears.
Setting is complete.
1810/D
DX 410E - DX 430E
+/-
keys.
www.dimplex.de/en