Num'axes Canicalm Guide D'utilisation page 13

In the factory, the On/Off switch is positioned on Off ; the stimulations switch is positioned on
beep sounds only and the sensitivity setting is in the medium position.
Fig. 1
Screwdriver
Start of Service
CANICALM is supplied with battery fitted.
Lift the n° 2 setting mask (Fig. 1) and turn the On/Off switch to On. After a few seconds, a beep
sound of 1.5 seconds will be emitted indicating that the collar is operating correctly.
Adjustment and positioning of the collar
The strap must be adjusted so that the contact points are in contact with the skin of the dog.
Collar adjustment is very important:
- If the strap is too loose, the collar is likely to move and repeated friction can irritate the skin of
your dog. Furthermore, it will not function correctly.
- If the collar is too tight, the dog will have breathing difficulties.
stimulation
inhibition
(beep sounds only)
Stimulations
switch
On/Off
switch
Regulating screw for bark detection sensitivity.
The system detects hardly any barking once the
screw is tightened to the end in the opposite
way of a watch pointers.
13
Fig. 2
short
stimulations
long
stimulations
bark
detection
contact
point
Off
On
GB