Final Steps; Install Door Handles - Whirlpool URB551WNGZ Mode D'emploi

Final Steps

1.
Check all holes to make sure that hole plugs and screws are
in place and are fully tightened�
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
2. Plug into a grounded 3 prong outlet�
NOTE: Allow refrigerator to stand upright at least 2 hours
before plugging in.
3. Return all removable door parts to door and food to
refrigerator�
NOTE: Wait at least 24 hours for your refrigerator to cool
completely before adding food. If you add food before the
refrigerator has cooled completely, your food may spoil�
10
A. Hinge plug

Install Door Handles

(on some models)
On some models the door handles are factory-installed� If your
refrigerator does not have factory-installed handles, see the
following instructions�
IMPORTANT: If you want to reverse the direction of the door
swing, so that the freezer and refrigerator doors open from the
opposite side, see "Reverse Door Swing" before installing the
door handles�
Parts Supplied: The door handles are packed inside the
freezer compartment, and the Reversibility kit containing the
screws and hole plugs is in the crisper drawer in the refrigerator
compartment�
Parts
■ Door handles (2)
■ Handle screws (4)
■ Handle plugs (4)
Gather the required tools�
Tools Needed: Phillips screwdriver
Install Handles
1. Remove the door handles from the packaging� Remove the
screws and hole plugs from the Reversibility Kit�
2. Using the screws, fasten the handles to the doors�
3. Insert the handle plugs to cover the screws�
Location
Freezer compartment
Crisper drawer
Crisper drawer